Do you worry about the removal of an old unit and the installation of a new head unit and dare not replace your factory radio with a new head unit? If you say yes, then you can read this article carefully, it’s a detailed 2002-2006 Chrysler Sebring head unit installation guide from Seicane. Please look at the image below, it’s the picture after installation, if you also have the same dashboard, you can take this instruction for reference.
2002-2010 Chrysler PT Cruiser car stereo after installation
Before and during installation, you should notice:
1.Before connecting, please make sure the ignition is off to avoid short circuit.
2.Ensure connect the yellow and red power cable at last.
3.Ensure that all loose wires are isolated with electrical tape
4.Ensure don’t tangle the wire when tighten the moving parts(Such as seat rails).
5.Ensure that all ground is connected to the same place.
6.Using the improper fuse may cause damage of fire, so when replace the fuse, please consult the professional.
2002-2006 Chrysler Sebring head unit installation guide
1.Loosen the trim panel with a lever.
1.Loosen the trim panel with a lever
2.Take the panel off the dash and disconnect the wires from the car.
2-1.Take the panel off the dash and disconnect the wires from the car.
2-2.Take the panel off the dash and disconnect the wires from the car.
3.Remove the four screws which are holding the unit with a screwdriver.
3.Remove the four screws which are holding the unit with a screwdriver.
4.Take out the unit and disconnect the wire harness at the back of the unit.
4-1.Take out the unit and disconnect the wire harness at the back of the unit.
4-2.Take out the unit and disconnect the wire harness at the back of the unit.
5.Connect the new wiring harness adaptor to the car, then, to the unit.
5-1.Connect the new wiring harness adaptor to the car, then, to the unit.
5-2.Connect the new wiring harness adaptor to the car, then, to the unit.
6.Connect the wire as the user manual shows and put the new unit into the dash.
6.Connect the wire as the user manual shows and put the new unit into the dash.
7.Turn on the new unit and have a test if the new Seicane unit is working without problem..
8.Put trim panel back on your new Seicane unit after the normal test.
Above all, if you find your dashboard is different from that shown in the guide picture, please don’t worry, the installation is similar, and you can still take it as a reference. If you have any question, you can consult your dealer or a professional. If you are still looking for an ideal unit for your car, then you can refer to this amazing 2002-2006 Chrysler Sebring head unit from Seicane, please click:
This wonderful 2002-2006 Chrysler Sebring head unit is upgraded on both the software and firmware, now you can replace your factory radio at a competitive price with higher performance. The RK PX3 1.6 GHz Quad-core CPU greatly facilitates the operation for you. Built with the latest GPS navigation system, you can easily arrive at a variety of locations with turn-by-turn voice guidance. To easily sync with your enabled mobile phone, you can get access to hands-free calls and music streaming which will make your journey safe as well as pleasant.
To have a different journey from now on, this Chrysler Sebring head unit is just your best choice! Good luck to you!
Recent Comments